![]()
#Make the cut 4 1 0 serial number serial#If you plan to netboot your router over a synchronous serial port adapter interface and have a boot image prior to Cisco IOS To display the clock rate value for the port adapter, use (if needed) to the nearest value that your hardware can support. #Make the cut 4 1 0 serial number series#Second-generation Versatile Interface Processors (VIP2s) in Cisco 7500 series routers, the clock rate you enter is rounded To permit a faster speed, use EIA/TIA-449 or V.35.įor the synchronous serial port adapters (PA-8T-V35, PA-8T-X21, PA-8T-232, and PA-4T+) on Cisco 7200 series routers, and on It is recommended that you only use the synchronous serial EIA/TIA-232 signal at speeds On your feature set, platform, and platform hardware.īe aware that the fastest speeds might not work if your cable is too long, and that speeds faster than 148,000 bits per secondĪre too fast for EIA/TIA-232 signaling. Support in a specific 12.2SX release of this train depends This command is supported in the Cisco IOS Release 12.2SX train. This command was integrated into Cisco IOS Release 12.2(33)SRA. This command was modified to include nonstandard clock rates for the PA-8T-V35, PA-8T-X21, PA-8T-232, and PA-4T+ synchronous The clock rate you enter is rounded (adjusted), if necessary, to the nearest You can enter any value from 300 to 8000000 bps. To remove the clock rate if you change the interface from aĭCE to a DTE device, use the no form of this command. Interface processors to an acceptable bit rate, use the clock rate command in interface configuration mode. To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and clock recovered adaptive/differential cem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |